The project implements an 8 byte RAM, 324 byte ROM and a random source supporting standard SPI read/write (03h/02h) and SPI quad read/write (6Bh/32h) commands. The quad read commands have 2 delay cycles.
The address map is:
| Address | Item |
|---|---|
| 0x000 | RP2040 boot stage 2 ROM |
| 0x100 | 8 byte RAM, wrapped 32 times |
| 0x200 | RP2040 program ROM |
| 0x300 | Mirror of the RAM |
| 0x400 | Random source |
See the README for more details.
Note the default project clk is a debug clock only, the project is internally clocked off SPI CLK, input 0.
You will need to use an SPI/QSPI master, unfortunately it was not possible to set up the pinout to support both QSPI and match the native RP2040 SPI block, so you'll need a PIO (Q)SPI implementation. I'll make that available before the chips are available.
The values in the RAM may be inspected by setting the address on the input toggle switches 2-5 and pressing the single clock button to latch the data, which is displayed on the 7 segment display and presented on uio pins 4-7. The default project clock should otherwise not be used - the project is clocked from the SPI clock.
The project is also designed to be used as a ROM connected to an RP2040's QSPI pins (instead of the more normal flash). You'll need a custom board for this as the QSPI pins are generally connected directly to a flash chip, I have a couple which I could potentially send to interested people in the UK - contact me on Discord.
A custom RP2040 board to make full use of the ROM
| # | Input | Output | Bidirectional |
|---|---|---|---|
| 0 | SPI CLK | segment a | SPI MOSI / D0 |
| 1 | SPI CSn | segment b | SPI MISO / D1 |
| 2 | Debug nibble select | segment c | D2 |
| 3 | Debug addr 0 | segment d | D3 |
| 4 | Debug addr 1 | segment e | Debug bit 0 |
| 5 | Debug addr 2 | segment f | Debug bit 1 |
| 6 | segment g | Debug bit 2 | |
| 7 | dot (Set to SPI CSn) | Debug bit 3 |